Maintenance; Introduction - Maintenance; Clean The Product - Husqvarna AUTOMOWER 535 AWD Operator's Manual

5.1 Introduction - maintenance

WARNING:
switched off before any maintenance is
done. The product is disabled when the LED
status indicator is not lit.
WARNING:
For better operation and longer service life, make sure
to clean the product regularly and replace worn parts. All
maintenance and servicing must be done according to
Husqvarna's instructions. Refer to
51 .
When the product is first used, the blade disc and
blades should be inspected once a week. If the amount
of wear during this period has been low, the inspection
interval can be increased.
It is important that the blade disc rotates easily. The
edges of the blades should not be damaged. The
lifetime of the blades varies immensely and depends for
instance on:
• Operating time and size of the work area.
• Type of grass and seasonal growth.
• Soil, sand and use of fertilizers.
• The presence of objects such as cones, windfalls,
toys, tools, stones, roots and the like.
The normal life is 3 to 6 weeks when used under
favorable conditions. Refer to
blades on page 30 on how to replace the blades.
Note:
Working with blunt blades gives a poorer
mowing result. The grass is not cut cleanly and more
energy is needed resulting in the product not mowing
such a large area.

5.2 Clean the product

CAUTION:
Never use a high-pressure
washer to clean the product. Never use
solvents for cleaning.
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass. Use a soft brush to
clean the product.
Husqvarna recommends to use a special cleaning and
maintenance kit, available as accessory. Speak to your
Husqvarna representative for more information.
1427 - 006 - 25.11.2021

5 Maintenance

The product must be
Wear protective gloves.
Warranty on page
Replacement of the
5.2.1 To clean the blade disc
Examine the blade disc and blades weekly.
1. Switch off the product. Refer to
product on page 27 .
2. Turn the product upside down or put it on its side.
Put the product on a soft and clean surface to
prevent scratching the product body.
3. Clean the blade disc with a brush.
4. Make sure that the blade disc can rotate freely.
5. Make sure that the blades are not damaged and
can pivot freely.
5.2.2 To clean the chassis
• Clean the bottom of the chassis with a brush or a
moist cloth.
To switch off the
Maintenance - 29