Operation; To Switch On The Product; Operating Modes - Husqvarna AUTOMOWER 535 AWD Operator's Manual

4.1 To switch on the product

WARNING:
safety chapter before you switch on the
product.
WARNING:
away from the rotating blades. Do not put
your hands or feet near or below the product
when the cutting motor is running.
WARNING:
when persons, especially children, or
animals are in the work area.
1. Push the ON/OFF button for 3 seconds to switch
on the product.
Note:
Make sure that the STOP button is
pushed down.
®
2. Use the Automower Connect app to enter the PIN
code. The correct PIN code must be entered to get
access to the menu. If the incorrect PIN code is
entered 5 times, the product is locked for a time.
The lock is extended for each new incorrect try.
3. Select the desired operating mode in the
Automower ® Connect app. Refer to
modes on page 26 .
4. Push the START button to start the product.

26 - Operation

4 Operation
Read and understand the
Keep your hands and feet
Do not use the product
Operating
If the product is parked in the charging station, it
will only leave the charging station when the
battery is fully charged and if the
let the product operate.

4.2 Operating modes

®
In the Automower Connect menu the following
operation modes can be selected:
• Main area
• Secondary area
• Park
4.2.1 Main area
Main area is the standard operating mode where the
product mows and charges automatically.
4.2.2 Secondary area
To mow secondary areas the operating mode
Secondary area must be selected. In this mode, the
operator must move the product manually between the
main area and the secondary area. The product mows
for a selected period of time or until the battery is empty.
4.2.3 Park
Park mode is selected the following operation
When the
selections can be chosen:
• Park until further notice
• Park for a specific number of hours
4.2.3.1 Park until further notice
The product goes to the charging station where it stays
until you select a different operating mode.
4.2.3.2 Park for a selected number of hours
The product goes to the charging station where it stays
for a selected number of hours, then it automatically
goes to the usual operation that is set in the
settings. This operation selection is applicable when it is
Schedule is set to
Schedule
1427 - 006 - 25.11.2021