Battery; Winter Service - Husqvarna AUTOMOWER 535 AWD Operator's Manual

2. Put the top cover in position (A) and push the 2
magnets to assemble the top cover (B).
A
B

5.5 Battery

WARNING:
using a charging station and power supply
which is intended for it. Incorrect use may
result in electric shock, overheating or
leakage of corrosive liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
WARNING:
recommended by the manufacturer. Product
safety cannot be guaranteed with other
batteries. Do not use non-rechargeable
batteries.
1427 - 006 - 25.11.2021
Only charge the product
Use only original batteries
CAUTION:
The battery must be
charged before winter storage. If the battery
is not fully charged it can be damaged and
in certain cases be rendered useless.
The charging time can vary depending on, among other
factors, the ambient temperature.
Below indicates that the battery is getting old and
eventually needs replacing:
• The operating time for the product is shorter than
normal between charges. This leads to more
charging cycles than normal, which increases the
risk of tracks forming near the charging station.
• The product is frequently found standing out on the
Empty battery message. This indicates
lawn with
that the product does not have battery capacity
enough to find the charging station.
The battery is fine as long as the product maintains a
well-cut lawn.
Note:
Battery life is dependent on the length of the
season and how many hours a day the product is
operating. A long season or many hours of use a day
means that the battery must be replaced more regularly.
Contact your local Husqvarna representative to replace
the battery.

5.6 Winter service

Take your product to your Husqvarna central service for
service prior to winter storage. Regular winter service
will maintain the product in good condition and create
the best conditions for a new season without any
disruptions.
Service usually includes the following:
• Thorough cleaning of the body, the chassis, the
blade disc and all other moving parts.
• Testing of the product's function and components.
• Checking and, if required, replacing wear items
such as blades and bearings.
• Testing the product's battery capacity as well as a
recommendation to replace battery if necessary.
• If new firmware is available, the product is
updated.
Maintenance - 33