Step 3: Installing The Software - Microtek XT7000 HS User Manual

Step 3: Unlocking the Scanner
Before using the scanner, the scanner should be unlocked. To unlock the
scanner, follow the steps below:
1. Remove the yellow sticker "Unlock
Scanner" from your scanner.
2. With the scanner power off, tilt the
front right corner of the scanner to see
the locking screw at the bottom.
3. Using a screwdriver, push and turn the
locking screw counterclockwise to the
unlock position.
When successfully unlocked, the screw
will push out a little, protruding slightly
from the bottom of the scanner.
If you have a need to transport the scanner, the scanner must be locked in
advance. To lock the scanner, follow the steps below:
1. Turn off the scanner.
2. Turn the scanner back on.
When the lights (LED indicators) on
the right side of the scanner light
on, use a screwdriver, and then
push and turn the locking screw
clockwise to the locked position.
When the screw has been tightened,
this indicates that your scanner is
locked.
3. Turn off your scanner.
XT7000 HS Scanner User's Manual
Unlocked
Locked
13