General Troubleshooting; Step 1: Telnet To The Emulation Probe; If You Cannot Connect To The Emulation Probe; Step 2: Check The Prompt - Agilent Technologies E5900B User Manual

General Troubleshooting

If you have trouble using the emulation probe, the following steps may help
you identify the problem. This troubleshooting procedure uses the built-in
command line interface. For more information on the command line interface,
see page 131.

Step 1: Telnet to the emulation probe

Use telnet to connect to the emulation probe across the LAN. (For
instructions on how to do this, see "Verifying LAN Communications" on
page 39.)
The emulation probe must be reachable via LAN before you can use it.

If you cannot connect to the emulation probe

If you cannot ping or telnet to the emulation probe ("Verifying LAN
Communications" on page 39):
• See "Problems with the LAN Interface" on page 145.
• If you need to change the LAN parameters of the emulation probe, see
Chapter 2, "Connecting the Emulation Probe to a LAN," on page 25.

Step 2: Check the prompt

Once you have connected to the emulation probe, press the Enter key a few
times and look at the prompt which is displayed.
If a telnet connection to the emulation probe
displays the prompt "->"
The "->" prompt indicates that the firmware loaded into the emulation probe is
not compatible with the "target board adapter" which is located inside the
Emulation for the Motorola M•CORE
Troubleshooting the Emulation Probe
General Troubleshooting
123