Before You Begin; Location Of Controls - FireplaceXtrordinair ProBuilder MV 42 Owner's Manual

6

Before You Begin


Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily
injury, or even death.

Location of Controls

There is a door on the lower portion of the screen assembly to provide access to the manual controls on
the fireplace. The door is held closed by two magnets. Open the door by gently pulling outward on the
upper portion of the lower trim.
Shutoff Valve
(accessible with
screen removed)
On/Off Switch
Pilot Igniter
Gas Control Knob
Flame Adjust Knob
Optional Remote Receiver The receiver is used in conjunction with the optional remote thermostat. It is
Optional Blower Dial
Optional Light Dial
© Travis Industries
Operation
Gas Control Knob
Flame Adjust Knob
Pilot Igniter
On/Off Switch
Optional Blower Dial
Optional Light Dial
Optional Remote Receiver
This control is used to turn the heater on and off.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly
next to the pilot, igniting the pilot flame.
This knob is used to control gas to the heater and for starting the pilot. There
are three positions, ON, OFF, & PILOT. The pointer to the left of the knob
indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.
used to control the remote and replaces the on/off switch for direct operation.
This dial controls the speed of the internal convection blower that pushes the
heated air into the room.
This dial controls the brightness of the optional accent lights (if applicable).
Rotate the Control Door Down to
4/24/18 - 1452
Access Controls
PB Lin MV Operation