Yaesu WIRES-X FT3DE Instruction Manual page 41

 FTM-100D
1. Press the [D X] key on the portable node FTM-100D transceiver.
The " X " icon flashes on the LCD screen.
• The display screen example uses the "Access Point" screen. In "Direct Operation",
"DIRECT" is displayed instead of frequency
• If the " X " icon does not blink when the [D X] key is pressed, communication between the
transceiver connected to the PC and the WIRES-X software has not been established, so
check the cable connection and USB driver installation.
• To cancel the connection, press and hold the [D X] key.
2. When the operation of the portable node is started, the " X " icon changes from blinking
to lit and the Node ID and the city of its own station are displayed.
Depending on the history of the previously connected node on the internet and the
current connection status of the portable node, one of the following four screens is
displayed.
If the portable node is not connected to a node or a room on the Internet
① When connection history is not stored
The connection destination display will be blank.
② When connection history is stored
The ID of the previously connected ID will blink.
Press the PTT switch to connect to the previously connected ID.
If the portable node is already connected to a node or a room on the Internet
③ When connected to the same node or room as the ID of the previous connection history
The current connection ID is displayed in the LCD. To communicate with this
connection, proceed to "Communicating with other station" (page 56).
④ When connected to a node or room different from the previous connection history
The "►" and the current connection ID are displayed on the LCD.
When the DIAL knob is turned, the previous connection ID will blink. In this
case, press the PTT switch to connect to the previous connection ID.
While operating the Portable Node, it may not be possible to switch between "Access Point" and "Direct Operation".
Press and hold the [D X] key to return to the transceiver setting screen, then press the [A/B] (DW) key.
While operating the portable node, the following functions may be set and operated on the portable node FTM-100D
transceiver.
Function
Return to the transceiver setting screen
Adjusts the squelch level
Enters the BACKTRACK screen
Selects the Transmission Power Level
Selects Speaker Mute
Turning the display ON and OFF
Disconnects a node or a room on the Internet
Key or Dial
Press and hold the D X key
Press the SQL (VOICE) key, then rotate the DIAL knob
Press the DISP (SETUP) key
Press the TX PO key or press the P4 key on the microphone (By
default setting)
Press the A/B (DW) key
Press and hold the DISP (SETUP) key
Press and hold the * key on the microphone
40