Yaesu WIRES-X FT3DE Instruction Manual page 26

 FTM-100D
On the frequency setting screen, you can set and operate the following with the transceivers key and DIAL knob settings.
Function
Switches between the Access Point and the Direct Operation
Starts operation for the Portable Digital Node
Sets the operation frequency
Selects the operating band
Recalls the "HOME" channel
Switches between the VFO mode and the Memory Channel mode
Registering to Memory Channel
Sets the transmit and receive DG-ID number
Enters the Set mode*
Enters the BACKTRACK (COMPASS) screen
Selects the Transmission Power Level
Reverses the transmit and receive frequencies
Squelch OFF
Adjusts the squelch level
Switches Busy detection between "Noise squelch" and "DG-ID
number match".
*
Some setting items in the set mode are automatically set for the Portable Digital Node function, so these settings cannot be used.
2. Setting the transmit and receive DG-ID number.
This procedure is unnecessary if the transceiver is already set to the required transmit and receive DG-ID
number.
Since the transmit and receive DG-ID number is "TX: 00" and "RX: 00", it operates as an open node and is
accessible from all transceivers using C4FM digital mode.
When using a portable node station to be accessed only by the specific members, set the transmit and receive
DG-ID to a number other than "00".
• In the Access Point, if the receive DG-ID is set to other "00", set the
number. Note that setting to a different number will not work properly.
• When setting the receive DG-ID number to "00" and then setting the transmission DG-ID number to anything other
than "00", the audio of all received C4FM digital stations will be heard on the speaker, but for the transmission DG-
ID Only the matched communication is relayed to the opposite station on the Internet.
• The DG-ID Subcode cannot be used or set in Portable Digital Node mode.
Key or Dial
Press the A/B(DW) key
Press the D X key or press the P3 key on the
microphone (by default setting)
Rotate the DIAL knob
Press the BAND(MHz) key
Press the P2 key on the microphone (by default setting)
Press the V/M(MW) key
Press and hold the V/M(MW) key
Press and hold the GM key
Press and hold the DISP(SETUP) key
Press the DISP(SETUP) key
Press the TX PO key or press the P4 key on
the microphone (by default setting)
Press and the P1 key ~ P4 key on the microphone*
*Setting of "REVERSE" function is necessary for P1
~ P4 keys in set mode.
Press the P1 key on the microphone (by default setting)
Press the SQL(VOICE) key, then rotate the DIAL knob
Press and hold the A/B(DW) key
transmit
25
DG-ID number to the same DG-ID