Perform The Self-Tests - Agilent Technologies 16962A Service Manual

3
Testing Logic Analyzer Performance

Perform the Self-Tests

24
When the logic analysis system has finished booting, the
Waveform window appears.
Before performing the self- tests, disconnect all probes
1
from the logic analyzer card.
Select HelpSelf-Test... from the main menu. The Analysis
2
System Self Tests window will appear.
In the Select suites list, select 16962A. Then, select All in the
3
Select tests list.
Select Start. This will perform a complete system self- test.
4
The progress of the self tests is displayed in the Results
5
area of the window.
6 When the self- tests are complete, check the Results
window to ensure that the Result Summary says that all
tests passed. If all tests did not pass, refer to
"Troubleshooting"
Select the Close button to close the Analysis System Self
7
Tests window.
If all module self- tests pass, then record "PASS" in the
8
"Logic Analysis System Self- Tests" section of the
Performance Test Record
on page 63.
(page 59).
16962A Logic Analyzer Service Guide