Table of Contents
Advertisement
7.1
Sending RS232 Commands Via SSH (URP49 / URP55 / URP65)
Control connection type must be changed to SSH through the Remote Monitoring Software to
allow sending commands via SSH. Changes are not applied until you click "Apply Changes".
The default username and password are:
•
Username = admin
•
Password = serial number
Notice the following in the SSH example below using Tera Term:
•
IP address is 10.15.0.72
•
Port 22 is selected
•
Service is set to "SSH"
•
SSH version is set to "SSH2"
If you entered the credentials correctly, the terminal will notify you that SSH connection
succeeded.
Planar UltraRes P Series RS232 User Manual
020-1408-02A
71
Page | 71
Advertisement
Table of Contents
