Display Unit - Planar Dome E2 User Manual

U.S. FCC Compliance Statement

Display Unit

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technical for help.
CAUTION: Changes or modifications to this equipment not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Video Adapter
The MX video adapter board included in this product has been tested and
listed to comply with FCC Class A by the manufacturer. To be compliant with
FCC requirements, the configured system utilizing the display and the
graphics controller must be tested by the integrator to ensure that the
entire system complies with FCC Class B.