Installing The Display - Planar Dome E2 User Manual

Installing the Display

Before you install the display controller, remove any existing graphics
card and its driver from your system. Disable any onboard graphics
capability on the motherboard.
Warning
In locations where 240V outlets are used, connect the Dome EX
display only to a center-tapped, 240V, single-phase supply (only
for Canada and the United States).
If you leave the computer turned on, you could get an electric shock
and cause damage to the system components.
Remove the display controller slowly from its package and static-
shielding bag to prevent an electrostatic discharge.
Static electricity can damage the controller. When touching the board
or parts of the motherboard, take these precautions:
• Wear an antistatic wrist strap.
• Discharge your body's static electricity repeatedly by touching
the power supply or the metal surface of the computer chassis.
Tips
• Access to ports. For displays mounted on a desk stand, rotate the
LCD panel from portrait to landscape for access to the ports.
• Threading cables. Remove the stand cover and thread the DVI cable
and power cord through the stand column. Make sure the cable and
cord run inside the notches. To reattach the cover, align the hooks
with the slots on the stand. Press the cover into place. A click sound
signals a secure connection.
Installing the Display | 5