Connecting the Display
Use only the cable and power cord supplied with the Dome EX display.
To connect the display
1 Plug one end of the DVI cable into
the DVI connector port. Tighten the
thumbscrews to secure the connection.
2 Plug the power cord into the power
input port.
3 Plug the other end of the DVI cable into
the video port on the installed display
controller. Use DVI port #1 (the bottom
port) to install the fi rst or only display.
4 Plug the other end of the power cord
into a grounded outlet.
5 Power on your display fi rst, then
the computer.
DVI
port 1
6
Power cord
Connection for
a single display
DVI cable
DVI cable
MX2 or MX3
board installed