Connecting Power, Turning Display On/Off; About Ups Supplies - Planar m40L Quick Start Manual

Connecting Power, Turning Display On/Off

The m40L can draw up to 2.0A at 100V or 1.0A at 200V. The
m46L can draw up to 2.6A at 100V or 1.3A at 200V. For countries
outside of North America, it is the responsibility of the installer
to provide the power supply cord certified for use in the desti-
nation country.
Connect a power cable to the power supply and to an AC
source. The power supply is auto-ranging, so it works with any
source from 100 to 240 VAC, 50 to 60 Hz.
The AC Master switch is located next
to the power receptacle, both of
which are located in the rear of the
display.

About UPS Supplies

Some installations use a UPS - Uninterruptible Power Supply.
Most UPS devices will work with the m40L/m46L. Review the
power specifications of your UPS device to make sure it is com-
patible with the m40L/m46L.
Turning Power On/Off
1 With the power cord attached, turn on the power switch
located on the back of the unit.
2 Turn on the m40L/m46L by aiming the
remote at the IR sensor in the lower
right corner of the screen (landscape)
or the lower left corner of the screen
(portrait), and pressing the
3 To turn off the m40L/m46L, press the
button.
OFF
button.
ON