Connecting The Display - Planar LA1550TS User Manual

Connecting the Display

To setup this display, please refer to the following figure and procedures.
1. Be sure all equipments are turned off.
2. Connect the Paint Booth Cable to the connector on the back cover of the monitor.
3. Connect the Extension Cable to the Paint Booth Cable and the other end to PC.
4. Connect D-SUB connector from the extension Cable to VGA output connector on
PC.
5. Connect RJ-45 connector from extension cable to USB Transmitter device and
connect USB Transmitter device to PC USB port.
6. Connect power connector to 110VAC power brick..
7. Connect Power cord to power brick and the other end into AC socket.
Notice!
To ensure the LCD display works well with your computer, please configure the display
mode of your graphics card to make it less than or equal to 1024 x 768 resolution and
make sure the timing of the display mode is compatible with the LCD display.
We have listed the compatible "Video Modes" of your LCD display in the appendix
(on page 18) for your reference.
Attention
This equipment is suitable for use in Class I, Division 2, Group A, B, C, D, or Non-
Hazardous Locations Only.
LA1550TS User Manual 9