Table of Contents
Advertisement
Settings for reliable feeding
Active Feeding
Enhanced Separation
Mixed paper
A-61931 April 2021
Active Feeding can help to align and prepare the leading edges of small
stacks (30 or fewer sheets) prior to feeding. If the document set for a
typical job is smooth paper of mixed sizes, Active Feeding can help it
feed reliably. To enable active feeding, refer to the TWAIN or ISIS driver
help or set-up guides. Set-up guides are available on the support page
for your model:
S2040:
www.alarisworld.com/go/S2040support
S2050:
www.alarisworld.com/go/S2050support
S2070:
www.alarisworld.com/go/S2070support
S2060w:
www.alarisworld.com/go/S2060wsupport
S2080w:
www.alarisworld.com/go/S2080wsupport
Enhanced Separation aids in reducing multifeeds at the start of
scanning. This feature is on by default because it is recommended for
all feeding applications. Page types that separate easily may feed
reliably with this feature turned off. Turning enhanced separation off will
allow scanning to begin slightly more quickly. To enable enhanced
separation, refer to the TWAIN or ISIS driver help or set-up guides. Set-
up guides are available on the support page for your model. For a list of
support page links, see "Active Feeding" on page 31.
Follow the tips in "Preparing documents for scanning" on page 29, and
above in "Settings for reliable feeding". Try to stack the input paper so it
is centered, side to side in the input tray. Lead edges should align or be
feathered.
If you want output pages to align at the trailing edge (which can be
useful when input pages are different lengths), raise the scanner on its
tilt stand:
1. Tip the scanner backwards.
2. Pull the tilt stand legs down until they snap into their extended
position. See "Underside view" on page 7.
3. Tip the scanner forwards until it rests on the tilt stand legs. This
configuration will encourage output pages to settle against the
scanner.
NOTE: Tilt stand legs are not available on the S2040.
3 Scanning
31
Advertisement
Table of Contents
