enTroubleshooting
Disturbance
Change program duration
changes during the
washing process.
Water is not visible
in the drum
bar.
Drum jerks
program start.
vibration and movement
the appliance during
spinning.
drum turns,
Water doesn't run in.
strong foaming
dung.
48
Cause and troubleshooting
No error - no action necessary.
▶
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Foam control system switches on a rinse cycle if the
foam builds up too much.
No error - no action necessary.
▶
Water is below the visible range.
No error - no action necessary.
▶
Do not add additional water to the device during
▶
operation.
The cause is an internal engine test.
No error - no action necessary.
▶
Device is not aligned correctly.
→ "Align device", page 17
▶
Device feet are not fixed.
Fix the device feet.
▶
→ "Align device", page 17
Transport locks are not removed.
→ "Remove transport locks", page 14 .
▶
Load detection is active.
No error, no action necessary.
▶
A notice:The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and fill the mixture
into the chamber for manual dosing (not for
outdoor, sportswear and down textiles).
If smart dosing is enabled, decrease the base
▶
dosing amount → page 36 .
If you dose manually, reduce the amount of
▶
detergent for the next wash cycle with the same
load.