Bosch WGG244A20 Instructions For Use And Assembly page 44

enTroubleshooting
Disturbance
"E:30 / -10" and/or
shines.
flashes.
All other error codes
of.
44
Cause and troubleshooting
Water level measurement system defective.
A notice:With the error message, the device starts
a pumping process.
First wait about 5 minutes until the pumping
1.
process is finished.
To reset the error message, switch off the device.
2.
Turn the device back on.
3.
If the error message appears again, call for service.
4.
→
"Customer Service", page 55
Detergent drawer is not fully pushed in.
Push in the detergent drawer until the symbol goes
▶
out.
Pump unit is not used.
Place the pump unit in the detergent drawer.
1.
→ "Cleaning the detergent drawer", page 36
Push in the detergent drawer until the symbol goes
2.
out.
temperature is too high.
Wait for the temperature to drop.
▶
→ "Cancel program", page 33
▶
Water level is too high.
Choose a suitable pumping program.
▶
→ "programs", page 26
door is not closed.
Close the door.
1.
Press to start the programStart/ Reload.
2.
Laundry is stuck in the door.
Open the door again.
1.
Remove trapped laundry.
2.
Close the door.
3.
Press to start the programStart/ Reload.
4.
malfunction
Call customer service.
▶
→
"Customer Service", page 55