Bosch WGG244A20 Instructions For Use And Assembly page 43

Disturbance
"E:36 / -10"
"E:10 / -00 / -10 /
- 20"
"E:60 / -2B"
"E:30 / -10" and/or
Cause and troubleshooting
If you dose manually, reduce the amount of
▶
detergent for the next wash cycle with the same
load.
Impermissible extension installed on the water drain
hose.
Remove impermissible extensions on the water drain
▶
hose.
→
"Connecting the device", page 15
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The handle of the pump
cover must be vertical.
Intelligent dosing system pump is blocked.
Turn off the device.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", page 36
Turn on the device.
3.
If the display reappears after cleaning the pump unit,
4.
call for service.
→
"Customer Service", page 55
A notice:You can deactivate the intelligent dosing
system and dose manually until the fault is rectified.
→
"Buttons", page 24
Imbalance control system stopped spinning due to
uneven laundry distribution.
Redistribute the laundry in the drum.
▶
A notice:Put large and small items of laundry together
in the drum. Items of laundry of different sizes spread
out better when spinning.
Water pressure is low. No
fix possible.
Filters in the water inlet are clogged.
Clean the filters in the water inlet.
▶
Water tap is closed.
Open the faucet.
▶
Water inlet hose is kinked or pinched.
Make sure the water inlet hose is not kinked or
▶
pinched.
Troubleshootingen
43