Disturbance
suds will not
pumped out.
Water doesn't run in.
Detergent will not
washed in.
Repeated
fling.
Change program duration
changes during the
washing process.
Cause and troubleshooting
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and fill the mixture
into the chamber for manual dosing (not for
outdoor, sportswear and down textiles).
If smart dosing is enabled, decrease the base
▶
dosing amount → page 36 .
If you dose manually, reduce the amount of
▶
detergent for the next wash cycle with the same
load.
Impermissible extension installed on the water drain
hose.
Remove impermissible extensions on the water drain
▶
hose.
→
"Connecting the device", page 15
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The handle of the pump
cover must be vertical.
Start/Reloadwas not pressed.
PressStart/Reload.
▶
Filters in the water inlet are clogged.
Clean the filters in the water inlet.
▶
Water tap is closed.
Open the faucet.
▶
Water inlet hose is kinked or pinched.
Make sure the water inlet hose is not kinked or
▶
pinched.
Imbalance control system compensates for imbalance by
distributing the laundry several times.
No error - no action necessary.
▶
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Program flow is electronically optimized. This can lead
to a change in the program duration.
No error - no action necessary.
▶
Imbalance control system compensates for imbalance by
distributing the laundry several times.
Troubleshootingen
47