Table of Contents
Advertisement
PROBLEM
The appliance
does not turn on
The infuser cannot
be extracted
At the end of
descaling, the
appliance requests
a third rinse
The milk does not
come out of the
milk spout
The milk contains
large bubbles
and squirts out of
the milk spout or
there is little froth
The machine
emits noises or
small puffs of
steam while not
in use
TROUBLESHOOTING
POSSIBLE CAUSE
It is not plugged into
the mains socket.
The main switch is not
turned on.
The appliance has not been
turned off correctly.
During the two rinse cycles,
the water tank has not been
filled to the
level.
MAX
The lid of the milk container
is dirty.
The milk is not cold
enough, or is not light or
skimmed milk.
The froth adjustment dial
is incorrectly adjusted.
The milk container lid or
froth adjustment dial
is dirty.
The hot water/steam
connection nozzle is dirty.
The machine is ready
for use, or has recently
been turned off, and
condensation is dripping
into the hot vaporiser.
WHAT TO DO
Plug into the mains socket.
Press the main switch.
Turn the appliance off by pressing
the standby button (see section 'Turning
the coffee maker off').
Follow the instructions displayed by
the appliance, but first empty the drip
tray to avoid the water overflowing.
Clean the milk container lid as described
in the 'Cleaning the milk container'
section.
Use light or skimmed milk at refrigerator
temperature (about 41°F (5°C)). If the
result is not as you wished, try using a
different brand of milk.
Adjust following the instructions in the
'Adjusting the foam level' section.
Clean the milk container lid and froth
adjustment dial as described in the
'Cleaning the milk container' section.
Clean the connection nozzle.
See 'Care and cleaning'.
This is part of normal operation.
To limit this occurring, empty
the drip tray.
53
Advertisement
Table of Contents
