Fisher & Paykel EB24DSX Installation Manual

INSTALLATION GUIDE
COMPANION COFFEE MAKER
ACCESSORY 30" TRIM KIT
Keep this document handy for easy reference.
This Trim Kit is designed to complement your companion product if installing into 30" wide cabinetry.
●
For contact information or if you require service, assistance or replacement parts, see the end of this document or your 'Service &
●
warranty' booklet.
This Trim Kit is designed to be installed ONLY with the FISHER & PAYKEL
- Companion Coffee Maker EB24DSX
- or in combination with OB30 Ovens
1 CABINETRY SPECIFICATION
PROUD INSTALL PROUD INSTALL
min.
* *
18 1/2"
(470mm)
*
min. 22 1/16" (560mm) Cutout to allow
min. 22 1/16" (560mm)
for Ventilation
1 15/16" (50mm)
Refer to separate
Product Install
Guide
PROUD INSTALL
18 13/16"
(478mm)
1 5/8" (42mm)
*
Cavity side walls must be
strong and structurally
supportive
to secure Trim Surround
●
to secure oven to
●
Note: Cavity Depth is
dependant on products used.
Trim Surround dimensions
29 13/16" (757mm)
1 5/8" (42mm)
18 13/16"
(478mm)
20 7/8" (530mm)
FLUSH (INSET) INSTALL FLUSH (INSET) INSTALL
1 5/8" (42mm)
* *
18 7/8"
(480mm)
*
min. 22 1/2" (572mm) Cutout to allow
min. 22 1/16" (560mm)
for Ventilation
1 15/16" (50mm)
Refer to separate
min. 29 15/16" (761mm)
Product Install
Guide
FLUSH (INSET) INSTALL
18 1/2"
(470mm)
18 7/8"
(480mm)
US CA
Trim Surround (1)
IMPORTANT!
INSTALLATION
WITH OB30
Ensure all packaging and protective film
●
is removed from the Trim Surround before
installing.
1 Mark the center of your cavity at the front.
*
2 Mount the Trim Surround with the small lip
resting flat on the front edge of the cabinetry
shelf.
3 Center the Trim Surround by lining up the
small cut "V" in the lip with your center mark
from Step 1.
Note: If installing Coffee Maker above an Oven,
ensure both products are centered and aligned
in the cabinetry.
INSTALLATION
WITH OB30
2 PARTS SUPPLIED
Product Support Rubber plugs (4)
Brackets (2) (for plugging spare
(for supporting your Trim Surround
companion product) holes
3 POSITION TRIM SURROUND ON CABINETRY
Line up the cut "V" with your cavity center mark
Trim Surround
Phillips Phillips
5⁄8" (16mm) 1 3/4" (45mm)
screws (8) screws (4)
(to secure (to secure the
the Product Trim Surround)
Support
Brackets)
Center line mark
Front edge of cavity
Center line mark
C L
Front edge of cavity
continued >