Default Loss Values For Succession Media Gateway - Nortel Meridian 1 Succession 1000 Manual

Default loss values for Succession Media Gateway

Succession transmission parameters
Table 103
Default Insertion Loss to WAN interface for North America (Part 2 of 2)
DGS
DSET
DAL
FXO
FXD
ATT
The pads on OPS line card are set to pads in, then OPS line card has 0 dB Tx
pad and 3 dB Rx pad. For DAL port, the loss plan assumes Succession 1000
Tx pad 0 dB and 6 dB for Rx pad. The pads on XUT trunk card for the FXO
port are set to pad out, which means –3 dB Tx pad and 0 dB Rx pad. The pads
on XEM trunk card for ATT port are set to Tx pad out and Rx pad in, which
means –1 dB Tx pad and 3 dB Rx pad.
Table 104 shows the default loss values. The default loss values are
applicable for North America. If no other loss values are configured in LD 73,
Page 229 of 236
WAN interface
0
0
-4
8
0
0
-6
0
-3
3
-3
3
Transmission Parameters