Stamina 35-1052A Owner's Manual page 14

OPERATIONAL INSTRUCTIONS
NOTE:
1. You may preset values for several functions. The preset function values will start to count down. When
you complete one of the preset functions, the value of this completed function will start to count up,
while the other preset functions will continue to count down.
2. The Meter will shut off automatically after 4 minutes of inactivity. All function values will be reset to
zero, except TOTAL COUNT.
3. The TOTAL COUNT will be reset to zero after batteries are removed for battery replacement or
storage of the unit.
HOW TO INSTALL AND REPLACE BATTERIES:
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AAA batteries (1.5V each), the
batteries are not included. Refer to the illustration to install or
replace the batteries.
NOTE:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according to
all state and federal laws and regulations.
5. Do not dispose of batteries in fire.
LOAD ADJUSTMENT
The resistance of the Shock can be adjusted by twisting the Adjustment
Knob at the top of the Shock. There are settings from 1 to 12. Setting #1
will provide the lowest resistance. Setting #12 will provide the highest
resistance.
CAUTION:
The shock gets
HOT
after a few minutes of use.
14
AAA Batteries
Adjustment
Knob
Mark