Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7409-K223
Summary of Contents for NCR 7409-K223
- Page 1 7409-K223/K225 Kit Instructions Issue D...
-
Page 2: Revision Record
Revision Record Issue Date Remarks Jan 2009 First issue Mar 2009 Kit PID changed to accommodate new 19” terminal; was 7409-K221 (longer ground cable) Dec 2009 Added JIS model July 2011 Added 7409-K225; was 7409-K224... - Page 3 Introduction This kit provides an MSR module that mounts on the side of the 7409 Display Head. There are two versions: JIS MSR (7409-K223) ISO MSR (7409-K225) 26439...
-
Page 4: Installation Procedures
Installation Procedures Warning: Disconnect the AC power cord before disassembling the Terminal. 1. Remove the Display Head from its mount. Removing the 7409 from the Table Top Mount a. Release the Mounting Plate Latches and tilt the display back. Relock the latches. - Page 5 b. Loosen the captive screw that secures the Cable Cover and remove the cover. Cable Cover Captive Screw 26690 c. Disconnect the cables from the I/O Panel. Terminal Power Cable Printer USB Cable Keyboard USB Cable 26445a...
- Page 6 d. Release the Mounting Plate Latches and remove the 7409 from the mount. Mounting Plate Latches Baseplate 26659 Removing the 7409 from the Fixed Angle Mount a. Remove the screws (2) in the sides of the Fixed Angle Mount. Screw (One on each side) 26681...
- Page 7 b. Rest the bottom of the display on the Display Support. Cable Cover Captive Screw Display Support 26680 Note: Place the Display Support behind the extension on then Display Hinge Bracket. Bracket Extension Display Support 24753 c. Loosen the captive screw that secures the Cable Cover and remove the cover.
- Page 8 d. Disconnect the cables from the I/O Panel. Note: The Power Cable connector locks into position when connected to the terminal and cannot be removed by simply pulling on the cable. You must grasp the connector and slide the outside housing out from the terminal to unlock it from the terminal connector.
- Page 9 Remove the display from the Fixed Angle Mount. 24629 g. Disconnect the Power Cord from the I/O Panel on the terminal. 2. Lay the terminal face down on a flat surface. 3. Loosen the captive screws (2) that secure the Rear Cover. Rear Cover Captive Screws 26903...
- Page 10 4. Pivot the Rear Cover to the open position. Rear Cover Latches 26651a 5. Remove the Rear cover by squeezing the Rear Cover Latches together as indicated above.
- Page 11 6. Remove the No MSR Cover (2 screws). No MSR Cover 26902 7. Insert the cables into the opening in the chassis and install the MSR Assembly in the slots of the cabinet. 26692 8. Secure the MSR to the chassis (2 screws).
- Page 12 9. Connect the MSR USB Cable to the I/O Board. 10. Connect the MSR Ground Cable to the chassis (screw). MSR Data Cable MSR Ground Cable 26691 11. Replace the Rear Cover and mount the Display Head to its mount using the reverse procedures.
- Page 13 NCR RealPOS and → → SelfServ Terminal and Operating Systems NCR RealPOS 25 (7610) Windows →[Operating System]. 3. Select the MSR Configuration Utility. For information about how to use the utility see the NCR MSR Configuration Utility User Guide (B005-0000-2031).