Main W&D; Main Dryer - Electrolux W585S Service Manual

Service Manual
83
13:15 COMPRESSED AIR IS MISSING
Machine indicates that compressed air is missing.
This error code will be shown if the control system detects that the input COMPRESSED AIR PRESENT is not
activated.
Recommended actions:
1. Check compressed air pressure to machine, valves is open, compressor on etc.
2. Check that input COMPRESSED AIR PRESENT activates when compressed air is present.
13:16 DRUM LOCK POSITION SWITCH
The error code is shown if inputs DRUM UNLOCKED and DRUM LOCKED are both active or inactive at the same
time during positioning sequence. By pressing the start button it is possible to have another trial.
Possible causes:
Heavy unbalance in drum that prevents the motor to position the drum. Worst case scenario is wet load in one com-
partment. Could also depend on problems with indexing sensors, washer I/O board or malfunction in mechanical
drum lock function.
Recommended actions:
1. Check inputs from indexing sensors FC1 and FC2.
2. Run a positioning sequence with wet load in one compartment to test functionality.
MAIN W&D
14:1 EXTRACTION FAILED DRYING ABORTED
Only on Wash & Dryer. If extraction is omitted, the drying sequence will also be omitted.

MAIN DRYER

15:2 UNLOADING DOOR OPEN
Only on Pocket washer:
This error code will be shown if the control system detects that the input DOOR CLOSED 2 (unloading side) has been
deactivated during an on-going program.
The error can only occur during an on-going program.
Possible causes:
This can be caused by for example a bad or defective door lock, loose cable to door lock, problem with door lock
edge connection, defective input on I/O unit type 10 etc.
Recommended action:
1. Check door lock functionality in service program, but activating door lock and then by checking inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock to locate intermittent errors.
15:3 UNLOADING DOOR NOT LOCKED
Only on Pocket washer:
This error code will be shown if the control system detects that the input DOOR LOCKED 2 has not been activated
within a certain time after unloading door is closed.
It will also be activated if the input DOOR LOCKED 2 has been deactivated during an on-going program.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock, loose cable connec-
tion to door lock, broken cables to door lock or mechanical problem with emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, but activating door lock and then by checking check inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
4. Check DLCU 2 status in service mode for more information on possible causes.