Electrolux W585S Service Manual page 82

82
13:10 WATER IN DRUM - CALL SERVICE
This error code will be shown if the control system detects water above safety level in idle mode. Possibly caused by
broken inlet valve and / or drain valve.
Recommended actions:
1. Turn off water inlet to machine.
2. Manually open the drain valve.
3. Check reason for valve malfunction.
13:11 UNLOADING DOOR NOT LOCKED
This error code will be shown if the control system has not detected the input UNLOADING DOOR LOCKED to be ac-
tive within a certain time after closing the unloading door.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock, loose cable connec-
tion to door lock, broken cables to door lock or mechanical problem with emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by monitoring input status
under Check inputs and outputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
13:12 LOADING DOOR NOT LOCKED
This error code will be shown if the control system detects that the input LOADING DOOR LOCKED has been deacti-
vated during an on-going program.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock, loose cable connec-
tion to door lock, broken cables to door lock or mechanical problem with emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by monitoring input status
under Check inputs and outputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
13:13 UNLOADING DOOR NOT LOCKED
This error code will be shown if the control system detects that the input UNLOADING DOOR LOCKED has been de-
activated during an on-going program.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock, loose cable connec-
tion to door lock, broken cables to door lock or mechanical problem with emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by monitoring input status
under Check inputs and outputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
13:14 INNER DRUM DOOR NOT CLOSED
This error code will be shown if the control system detects that the input INNER DOOR OPEN is activated during pro-
gram start or becomes activate when drum is ordered to drive/drum is rotating.
Recommended actions:
1. Check functionality of INNER DOOR OPEN SENSOR (DP7), i.e inactive when door is closed and active when
door is open.
2. Check door lock functionality in service program, by activating door lock and then by monitoring input status
under Check inputs and outputs.
Service Manual