Service Manual
55
I/O module type 10
Disconnect the power to the machine.
Demount the top panel.
Remove the cover to the control system and I/O module type 10.
Remove the electrical connections on the module. (Note the position of the connections).
Loosen the screw (A) a bit and remove the I/O module by lifting it upwards.
fig.7801
Insert the new module and make sure it is in position.
Connect the electrical connections in the same way as before.
Fasten the screw (A) and remount the cover.
Remount the top panel.
Connect the power to the machine.