Sennheiser 506824 Instruction Manual page 9

Overview of the Receiver status LED
Receiver status LED
–
lights up green
lights up red
1s 1s
flashes green
1s 1s
flashes red
Overview of the Transmitter status LED
Transmitter status LED The transmitter...
–
lights up white
lights up blue
flashes blue and white
The LEDs on the stethoset receiver and on the transmitter indi-
cate the current operating state. If you are not pressing any
button on the stethoset receiver, the LEDs automatically dim
after approx. 30 seconds to not disturb you.
Overview of the acoustic signals/beeps
Beeps...
during operation, 
2 beeps
during operation, no audio
transmission, 5 beeps
when changing the volume The maximum or minimum volume is
when changing the balance
setting
The stethoset receiver...
... is switched off.
... is connected to the transmitter.
... is connected to the transmitter, the
rechargeable battery is almost empty.
... is not connected to the transmitter or
cannot connect to the transmitter.
... is not connected to the transmitter or
cannot connect to the transmitter, the
rechargeable battery is almost empty.
... is in standby mode.
... and stethoset receiver are connected.
The speech intelligibility function is
deactivated (see page 26).
... and stethoset receiver are connected.
The speech intelligibility function is
activated (see page 26).
... has detected an incompatible digital
audio signal (see page 12).
Meaning
The rechargeable battery is almost
empty, recharge it (see page 16).
The receiver is outside the
transmission range (see page 37).
reached (see page 22).
The maximum or minimum balance
setting is reached (see page 23).
Product overview
RS 5000 | 9