Sennheiser 506824 Instruction Manual page 31

Battery status display
This setting is saved on the transmitter, independent of the ste-
thoset receiver you are using.
To change the battery status display:
Make sure that the protected settings mode is activated (see
page 30).
Press the Balance button L.
Status and display of
the Battery LED
permanently
activated (operation
and charging)*
st
1 LED segment lit
activated for
30 seconds
(operation and
charging)
st
1 LED segment off
Save the setting by disconnecting the transmitter from the
power supply system (see page 30).
Charging reminder function
This setting is saved on the transmitter, independent of the ste-
thoset receiver you are using.
To activate or deactivate the function:
Make sure that the protected settings mode is activated (see
page 30).
Press the Balance button R.
Status and display of
the charging
reminder function
activated*
rd
3 LED segment lit
deactivated
rd
3 LED segment off
Save the setting by disconnecting the transmitter from the
power supply system (see page 30).
Using additional functions
Function/behavior
The current charge status is permanently
displayed during charging.
The remaining charge status is
permanently displayed during operation.
The current charge status is displayed for
30 seconds during charging. Then all LEDs
go off. The charging process is continued.
The remaining charge status is displayed
for 30 seconds during operation. The
battery status display then goes off.
Function/behavior
When you switch the stethoset receiver off
and the transmitter switches to standby
mode, the battery status display will flash
for 10 minutes to remind you to charge the
stethoset receiver.
After switching the wireless headphone
system off, all LEDs remain off.
* factory setting
* factory setting
RS 5000 | 31