Power Cord - Rheem IKONIC RTGH-S11i Manual

IKONIC Tankless Water Heater Service Manual
HOW TO REMOVE COMPONENTS
CONTROL BOARD BRACKET
1. Remove all 9 connectors from the control board.
2. Remove top center screw from control boardmount-
ing bracket, and 2 screws located on bottom.
3. Pull control board bracket out of the way to access
components.
78

POWER CORD

1. Locate YELLOW Molex connector attached to power
cord.
2. Disconnect YELLOW Molex connector and remove
two screws from control board bracket as pictured
below.
3. Pull grommet and cord through bottom of water
heater cabinet.