M.2 Solid-State Drive Bracket - Lenovo ThinkCentre neo 50t Gen 3 Hardware Maintenance Manual

Note: Remove the film that covers the thermal pad (if any) when installing the M.2 solid-state drive and the
heat sink.

M.2 solid-state drive bracket

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the computer cover. See "Computer cover" on page 44.
2. Remove the front bezel. See "Front bezel" on page 44.
3. Remove the drive bay assembly. See "Drive bay assembly" on page 47.
4. Remove the M.2 solid-state drive and the heat sink. See "M.2 solid-state drive and the heat sink" on
page 52.
.
Chapter 5 Hardware removal and installation
55