Table of Contents
Advertisement
Gimbal
Knob
Rear View
Figure 32
4. Route the Cables
In this procedure, you will route the power
and transducer jumper cables on the
underside of the base, and attach the tie-
down straps that will be used to secure
the battery to the base in a later
procedure.
1. Turn the base upside down, then
thread the two included hook and
loop battery tie-down straps from
the bottom of the base up through
each side of the battery well, using
the strap holes (see the illustration
Attaching the Battery Tie-Down
Straps).
Attaching the Control Head to the Base and Handle
Pivot
Knuckle
Thumbknob
Bolt
25
Front View
Attaching the Battery Tie-Down Straps
Figure 33
Gimbal
Knob
Battery
tie-down straps
Portable Case Assembly
Advertisement
Table of Contents
