7. Assemble the Transducer Mounting Bracket
In this procedure you will assemble the portable transducer mounting bracket.
1. Line up the two ratchet pieces at position 1 so that the beads are
aligned with the rib on the transducer. See the illustrations.
Transducer Knuckle Positions
Figure 40
2. Assemble the other transducer parts as shown (see the illustration
Assembling the Portable Bracket below). Hand tighten only!
Suction Cup
Portable Transducer Assembly
Knuckle
Assembling the Portable Bracket (XNT 9 28 T)
Washer
Wing Nut
Figure 41
Ratchets Placed in Position 1
Rib at
position 1
Portable
Transducer
Assembly
Phillips
Head Screw
30
Beads
Ratchet
Bolt
Ratchet