Route The Control Head Cables Under The Deck - Humminbird PiranhaMAX 197c Installation And Operation Manual

4. Route the Control Head Cables Under the Deck

Use the following steps to route the control head cables under the deck.
NOTE: Under the deck cable routing is not always possible. If this is not an option, the
cables should be routed and secured above deck.
NOTE: See Transom Transducer Installation to plan the location of the transducer
and cable route.
Tilt and Swivel Mount Control Head Base
Figure 6
Route the Cables
1a. Mark and drill a 3/4" (19 mm) hole
as shown in Figure 6. Route the
cables through the hole. The cables
will exit through the center hole on
the control head base.
or...
1b. If the cables cannot be routed
directly beneath the control head
base, mark and drill a 3/4" (19 mm)
hole that will allow you to run the
cables close to the control head
base.
5
Fixed Control Head Installation