Table of Contents
Advertisement
Partially install two light kit assembly
screws, found in the
bag, halfway into the motor housing
as shown. It does not matter which
two screw holes you choose.
Partially install two of the light kit screws
found in the
bag. It does not matter
which two screw holes you choose. Connect
the plugs from the upper and lower switch
housings. Make sure to line up the colored
markings on the connectors.
Note:
Fan style may vary.
Install the
included bulbs
into the sockets.
When necessary,
replace with
bulbs of same
wattage.
Note:
Fan style may vary.
Ceiling Bracket
Downrod
Assembling the LIght Kit
2 of 5
Light Kit Screw
bag
hardware
2 of 5
Light Kit Screw
bag
Lift and align the keyhole slots in the
light kit housing with the two screws.
Make sure all the wires from the fan
and the light kit are snug inside the
center of the light kit, not pinched in
between the upper switch housing and
the light kit or hanging out of the sides.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan
Wiring
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole slots
around the screws and twist
counterclockwise.
Installing the Glass
Tab
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Canopy
Blades
Insert the third screw,
found in the
bag, into place and then
tighten all three screws.
Turn the light kit counterclockwise until the
switch housing screws are firmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
Bulbs
Remote
1886
1 of 5
Light Kit Screw
bag
hardware
This is a screw you saved that
was attached to the red flag.
Light Kit Screw
8
Remote Cradle
Advertisement
Table of Contents
