Installing The Canopy; Installing The Blades - Hunter Kempton Park Installation Manual

1886
Note:
Fan style may vary.
Follow these steps to prepare the light fixture for installation.
Red Flag
7
Ceiling Bracket Downrod

Installing the Canopy

Lift the canopy into place so that
the screw holes are aligned.

Installing the Blades:

Attach each blade to a blade iron using the blade washers, found in the
bag, and the blade assembly screws, found in the
Repeat x6
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Preparing the Light Fixture
Fixture Screw
Remove the pre-installed fixture screw and red
flag from the light kit assembly. Save the screw.
It will be needed for light kit installation.
Note: The screw was installed for shipping purposes only.
Hanging Fan Wiring
Insert the two canopy screws
found in the
hardware bag.
IMPORTANT
KEEP
Carefully remove the light fixture
from the light fixture assembly
and set the light fixture aside.
Canopy Blades
hardware bag.
bag
hardware
bag
bag
Note:
Fan style may vary.
Light Bulbs Remote
x2
Canopy Screw
x18
Blade Screw
x18
Blade Washer
Remote Cradle