Ricoh PD-D1 Field Service Manual page 206

4. Appendix: Service Program Mode Tables
Idling after how many prints
• If SP 2-28 is set to 'YES', the idling motor turns if 3 or more prints were made.
2-29
• If SP 2-28 is set to 'NO', the idling motor turns if the number of prints made is the same
as or more than the setting of SP 2-29.
2-31 Ink Auxiliary Supply
Ink supply after trial
2-32
Ink is detected and supplied after the trial print when this SP is on.
Re-Feeding setting
When the machine performs re-feeding, the paper registration position can be up to 5mm
out of range. If this position is not acceptable to the customer, change this SP mode to
2-33
"OFF".
• ON: Re-feeding is on (factory setting).
• OFF: Re-feeding is off.
Slow starting mode
Increase the image density of trial prints.
The figures below are drum-rotating speeds. A setting of "30rpm" will increase the image
density of trial prints.
This mode was added because trial print images are lighter than with other models.
<30rpm>
2-34
• Trial Print: 30rpm
• 1st Print: 45rpm
• 2nd Print: 60rpm
• 3rd Print: 75rpm
• 4th Print: 90rpm
• 5th Print: 105rpm
• 6th Print: 130rpm
Print pressure fixing mode
This function is used to specify whether the print pressure point is set to automatic or fixed.
2-35
• Auto: Decide on Sp6-70 to 87
• Fixed: Decide on SP2-36
SP2-37setting is not reflected.
28
[1 to 5 / 3 / 1 Print]
[0:After 1:Before 2:No / 0:After / - ]
[ ON-OFF / OFF / -]
[ ON-OFF / ON / -]
[30rpm / 45rpm / 45rpm /-]
<45rpm>
• Trial Print: 45rpm
• 1st Print: 60rpm
• 2nd Print: 75rpm
• 3rd Print: 90rpm
• 4th Print: 105rpm
• 5th Print: 130rpm
• 6th Print: 130rpm
[ON - OFF / ON / -]