Husqvarna FC 450 2023 Owner's Manual page 87

SERVICE WORK ON THE CHASSIS 11
–
Move the hydraulic clutch fluid reservoir mounted on the han-
dlebar into a horizontal position.
–
Remove screws
–
Take off cover
H04933-10
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap and
mount bleeding syringe
on bleeder screw
–
Only loosen bleeder screw
until filling is possible.
H04934-10
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
Avoid contact between brake fluid and painted parts.
Brake fluid corrodes paint.
Only use clean brake fluid from a sealed container.
–
Now press the fluid into the system until it emerges from
6
hole of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Tighten the bleeder screw and remove the bleeding syringe
with the hose. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
H04932-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
1
.
2 3
with membrane .
4
with the appropriate hydraulic fluid.
p. 146)
4
with an appropriate hose piece
5
.
5
on the clutch slave cylinder
4 mm (0.16 in)
85