Husqvarna FC 450 2023 Owner's Manual page 51

Main work
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove the screws
3
support .
Adjusting the handlebar position with the handlebar clamp in
the rubber bearing
–
Position the rubber bushings
–
Place the handlebar support in the required position.
Info
The handlebar support is longer and higher on one
side.
A01169-10
–
Mount and tighten the screws
Guideline
Screw, handle-
bar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned
correctly.
–
Position handlebar clamp
–
Mount screws
–
First bolt the handlebar clamp with screws
longer, higher side of the handlebar supports so that both
parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
TUNING THE CHASSIS 10
1
. Take off handlebar clamp
7 6
and bushing . Take off handlebar
4 5
and
7
with bushing
M10 40 Nm (29.5 lbf ft)
2
.
1
, but do not tighten yet.
1
evenly.
M8 20 Nm (14.8 lbf ft)
2
. Take off
.
6
.
®
Loctite 243™
1
onto the
49