Table of Contents
Advertisement
Escape 1800-I Insert Installation and Operation Manual
2. General Information
2.1 Appliance performance
Fuel type
Recommended heating area
Firebox volume
Maximum burn time
Maximum heat output
Overall heat output rates (min. to max.)
Average overall efficiency
Optimum efficiency
Average particulate emissions rate
(9)
Average CO
[*]
Recommended heating area and maximum burn time may vary subject to location in home, chimney
draft, heat loss factors, climate, fuel type and other variables. The recommended heated area for a given
appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature
in the designated area in case of a power failure.
(1)
Values are as measured per test method, except for the recommended heating area, firebox volume,
maximum burn time and maximum heat output.
(2)
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
3
lb/ft
. Other performances are based on a fuel load prescribed by the standard. The specified loading
density varies between 7 lb/ft³ and 12 lb/ft
(3)
As measured per CSA B415.1-10 stack loss method.
(4)
Higher Heating Value of the fuel.
(5)
Lower Heating Value of the fuel.
(6)
Optimum overall efficiency at a specific burn rate (LHV).
(7)
This appliance is officially tested and certified by an independent agency.
(8)
Tested and certified in compliance with CFR 40 part 60, subpart AAA, section 60.534(a)(1(ii) and Draft
ASTM WK47329-14
(9)
Carbon monoxide.
8
(1)
[*]
[*]
(2)
(dry cordwood)
(3)
– Dry Cordwood
(2)(6)
(7)
3
. The moisture content is between 19% and 25%.
Dry cordwood
500 to 2,100 ft
3
2.4 ft
(0.068 m
8 h
75,000 BTU/h (22.0 kW)
14,800 BTU/h to 28,600 BTU/h
(2)(3)
(4.34 kW to 8.38 kW)
69 % (HHV
77 %
1.54 g/h (EPA / CSA B415.1-10)
89.4 g/h
2
2
(47 to 195 m
)
3
)
(4)
)
74 % (LHV
(8)
(5)
)
3
and 20
Advertisement
Table of Contents
