Toyota Prius c 2014 Owner's Manual page 55

■
Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless
remote control.
STEP 1 Turn the "POWER" switch off.
STEP 2 When the indicator light on the key surface is not on, press and
hold
.
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at
least 5 seconds, and repeat step 2.)
Unlocking doors
Holding the driver's door handle
unlocks only the driver's door.
Holding the front passenger's door
handle unlocks all the doors.
Holding either front door handle
unlocks all the doors.
■
Battery-saving function
The battery-saving function will be activated in order to prevent the elec-
tronic key battery and the 12-volt battery from being discharged while the
vehicle is not in operation for a long time.
●
In the following situations, the smart key system may take some time to
unlock the doors.
• The electronic key has been left in an area of approximately 6 ft. (2 m)
of the outside of the vehicle for 10 minutes or longer.
• The smart key system has not been used for 5 days or longer.
●
If the smart key system has not been used for 14 days or longer, the
doors cannot be unlocked at any of the doors except the driver's door. In
this case, take hold of the driver's door handle, or use the wireless
remote control or the mechanical key, to unlock the doors.
1-3. Opening, closing and locking the doors
or for about 5 seconds while pressing and holding
Beep
Exterior: Beeps 3 times
Interior: Beeps once
Exterior: Beeps twice
Interior: Beeps once
1
53