Programming The Primary Filter - Sundance Spas 880 Series Owner's Manual

12.2

Programming the Primary Filter

To access the "Primary Filter" feature, tap
menu, Figure 12.2a, to enter the "Primary Filter" programming, Figure
12.2.b.
Heat & Filter
A
A
Auto
Economy
Day
1
Figure 12.2a
During a primary filtration, the circulation pump, CLEARRAY and ozone
unit (if applicable) are activated. The factory default cycle starts at 12:00
AM and last for 8 hours. If you elect to keep this setting, then you can
skip this section.
In extreme bitter cold weather, where freezing can occur,
we recommend you program the circulation pump to run 24
hours. Refer to the "Winterizing" section on page 52.
Any time the circulation pump runs outside of a program cycle, e.g. for
heating, that run time will be deducted from the next primary filter cycle.
For example, the primary filter cycle is set to 8 hours every 24 hours but
the circulation pump comes on for 2 hours to heat the water after the
cycle has finished. The next primary filter cycle will only be for 6 hours
not 8 hours.
A. To change the default cycle:
When you enter the menu, certain icons will be
highlighted, Figure 12.2c.
Note: If is pressed, in the middle of
programming, it will clear the changes made and
revert to the prior programmed settings. This
feature can be used to make corrections.
1. Tap or
increments. To switch from "AM" to "PM" you must
round a 12-Hour period.
2. Tap to accept and save the change.
3. Tap to program the end time for the cycle.
End
4. Tap or
from "AM" to "PM" you must round a 12-Hour period.
5. Tap to accept and save the change.
6. Tap to return to the Heat and Filter Menu. Tap again to return to
the Settings Menu.
Filter 2
to change the hour in 1-hour
to change the hour in 1-hour increments. To switch
from the Heat and Filter
1
A Primary Filter
A
8:00
PM
Start
Figure 12.2b
A Primary Filter
A
Start
880 Export Series
End
8:00
PM
End
Figure 12.2c
37