Sundance Spas 880 Series Owner's Manual page 45

4. Tap to return to the "Water Care" Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control panel
display. The water must be drained and replaced with fresh water.
Follow the instructions above to reset the timer. If you tap "snooze"
the message will clear but the error icon
reminder screen will reappear in 10 days. Refer to Section 13.3,
page 49, for filter location.
C. Programming the MicroClean® Outer Filter Timer
A programmable filter timer can be set to remind
you when to clean or replace the MicroClean
Outer Filter. Tap
enter the Programming Menu.
1. From the "Water Care" Menu you can to set
the MicroClean Outer timer, Figure 12.6e.
2. Tap or
increments. The range is from OFF to 180
days. It is not recommended that this feature be turned
OFF. In order to continually maintain clean and working filters, it
should be program as instructed.
Note: Pressing
revert to the previous programmed setting. This feature can be used to
make corrections.
3. Tap to confirm and save your changes.
4. Tap to return to the "Water Care" Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control
panel display. The filter must be cleaned or replaced. Follow the
instructions above to reset the timer. If you tap "snooze" the message
will clear but the error icon
will reappear in 10 days. Refer to Section 13.1, page 46, for
cleaning instructions.
D. Programming the MicroClean® Inner Filter Timer
A programmable filter timer can be set to remind
you when to replace the MicroClean Inner Filter.
Tap
MicroClean Inner 50
Programming Menu.
1. From the "Water Care" Menu you can to set
the MicroClean Inner timer, Figure 12.6f.
2. Tap or
increments. The range is from OFF to 90
days. It is not recommended that this feature be
turned OFF. In order to continually maintain clean and working filters,
it should be program as instructed.
Note: Pressing
revert to the previous programmed setting. This feature can be used to
make corrections.
(Figure 12.6b) to
MicroClean Outer 60
to change the days in 10-day
will clear any current changes made. The days will
(Figure 12.6b) to enter the
to change the days in 10-day
will clear any current changes made. The days will
will display and the
will display and the reminder screen
880 Export Series
A MicroClean Outer
A
60 Days Left 60
days
Figure 12.6e
A MicroClean Inner
A
50 Days Left
50
days
Figure 12.6f
41