Battery Connections - Elation KL PANEL PO User Manual

B AT T E R Y C O N N E C T I O N
The KL Panel can receive power from a battery pack.
NOTICE: The user is responsible for ensuring compatibility between the device and the
battery pack. Always ensure that the output specifications, operating conditions, and
connection pinouts of the battery pack match the device requirements.
The device features a 4-pin XLR connector for battery power. The connector is located on the
back of the device, next to the DMX In/Out connectors, and is covered with a dust cap.
BE CAREFUL NOT TO CONNECT BATTERY POWER TO ONE OF THE DMX CONNECTORS BY
MISTAKE!
The pinout is illustrated below:
Consult the Safety Guidelines section of this user manual, as well as any safety instructions
included with your battery pack before use or installation.
The KL Panel consumes 300W when operating all LEDs at full output, which may require sig-
nificant battery output to provide the required power. To extend the battery life, it is pos-
sible to reduce the LED power down to 50% of maximum output using the "LED Power Limit"
menu in the Personality section of the system menu. Please refer to the System Menu sec-
tion of this manual for detailed information.
18