Elation KL PANEL PO User Manual page 10

I N S TA L L AT I O N I N S T R U C T I O N S
FLAMMABLE MATERIAL WARNING
Keep fixture minimum 5.0 feet (1.5m) away from flammable materials and/or
pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
USE CAUTION WHEN POWER LINKING FIXTURES OF OTHER MAKES AND MODEL
TYPES, AS THE POWER CONSUMPTION OF OTHER MODEL FIXTURES MAY EXCEED
THE MAX POWER OUTPUT ON THIS FIXTURE. CHECK SILK SCREEN FOR MAX AMPS.
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial electrical and
construction codes and regulations.
Before rigging/mounting a single fixture or multiple interconnected fixtures for custom matrix
designs to any metal truss/structure or placing the fixture(s) on any surface, a professional
equipment installer MUST be consulted to determine if the metal truss/structure or surface
is properly certified to safely hold the combined weight of the fixture(s), clamps, cables, and
accessories.
Maximum fixture ambient operating temperature 113°F (45°C). Do not operate this fixture
when ambient temperature exceeds this value.
Fixture(s) should be installed away from walking paths, seating areas, or areas where
unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the fixture(s) when rigging, removing or servicing.
Overhead fixture installation must always be secured with a secondary safety attachment,
such as an appropriately rated safety cable that meets all local, national, and country codes
and regulations. Allow approximately 15 minutes for the fixture to cool down before servicing.
10