Panasonic AG-UX170 Operating Instructions Manual page 76

2
Use INPUT1 or INPUT2 switches to switch the connected audio input signal.
*1
LINE : Audio equipment is connected
*2
MIC : An external microphone is connected
*2
+48V : When using a phantom microphone (which requires a power supply of +48 V)
*1 The input level varies depending on the [INPUT1 LINE LEVEL] or [INPUT2 LINE LEVEL]
setting. (l 191)
*2 The input level varies depending on the [INPUT1 MIC LEVEL] or [INPUT2 MIC LEVEL] setting.
( )
l 191
3
Use the CH1 SELECT switch to select the input signal to be recorded to
audio channel 1.
INT(L): Audio from the built-in microphone L (left) ch is recorded to audio channel 1.
INPUT1: Audio from a device connected to AUDIO INPUT1 terminal (XLR 3 pin) is recorded to channel 1.
INPUT2: Audio from a device connected to AUDIO INPUT2 terminal (XLR 3 pin) is recorded to channel 1.
4
Use the CH2 SELECT switch to select the input signal to be recorded to
audio channel 2.
INT(R): Audio from the built-in microphone R (right) ch is recorded to audio channel 2.
INPUT1: Audio from a device connected to AUDIO INPUT1 terminal (XLR 3 pin) is recorded to channel 2.
INPUT2: Audio from a device connected to AUDIO INPUT2 terminal (XLR 3 pin) is recorded to channel 2.
∫ Table of audio input patterns
Switch setting
CH1 SELECT
switch
INT(L)
INPUT1
INPUT2
To remove the external microphone, etc., from the AUDIO INPUT1, 2 terminals
(XLR 3 pin)
Remove while pushing on the PUSH section of the AUDIO
INPUT1, 2 terminals (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching
the CH1 SELECT, CH2 SELECT switches to INT (L) or
INT (R) after removing the external microphone. Audio
will not be recorded when motion picture is recorded
without switching.
CH2 SELECT
switch
INT(R) built-in microphone Lch
INPUT1 built-in microphone Lch
INPUT2 built-in microphone Lch
INT(R) AUDIO INPUT1 terminal
INPUT1 AUDIO INPUT1 terminal
INPUT2 AUDIO INPUT1 terminal
INT(R) AUDIO INPUT2 terminal
INPUT1 AUDIO INPUT2 terminal
INPUT2 AUDIO INPUT2 terminal
Channel or terminal used for signal input
Audio channel 1
A PUSH section
- 76 -
Audio channel 2
built-in microphone Rch
AUDIO INPUT1 terminal
AUDIO INPUT2 terminal
built-in microphone Rch
AUDIO INPUT1 terminal
AUDIO INPUT2 terminal
built-in microphone Rch
AUDIO INPUT1 terminal
AUDIO INPUT2 terminal