Panasonic AG-UX170 Operating Instructions Manual page 6

About the AC adaptor/battery
charger
≥ If the temperature of the battery is extremely
high or extremely low, charging may take time
or the battery may not be charged.
≥ If the CHARGE indicators keeps flashing in
orange, make sure that the terminals of the
battery or the battery charger are not
exposed to dirt, foreign objects or dust, then
reconnect them properly.
Disconnect the AC cable from the AC outlet
when you remove dirt, foreign objects or dust
on the terminals of the battery or the battery
charger.
≥ If the battery's temperature is excessively
high or excessively low, the CHARGE
indicators will blink orange. Charging will start
automatically when the battery reaches an
acceptable temperature for charging.
≥ If the CHARGE indicators blinks orange when
the battery's temperature is normal, the
battery or the battery charger may be
malfunctioning. In such cases, contact your
dealer.
≥ If you use the AC adaptor or battery charger
near a radio, radio reception may be
disturbed. Keep the AC adaptor or battery
charger 1 m or more away from the radio.
≥ When using the AC adaptor or battery
charger, it may generate whirring sounds.
However, this is normal.
≥ After use, be sure to disconnect the AC cable
from the AC outlet. (If you leave this unit
connected, the AC adaptor will consume
approximately 0.1 W.)
≥ Always keep the electrodes of the AC
adaptor, battery charger and battery clean.
≥ Install the device near an AC outlet so that
the power disconnection device (AC
mains plug) can be accessed easily by
hand.
About the SD card
When disposing of or giving away the SD
card, note that:
≥ Formatting and deletion of this unit or
computer only changes the file management
information and does not completely delete
the data in the SD card.
≥ It is recommended that the main SD card is
either physically destroyed or the SD card is
physically formatted using this unit when
disposing of or giving away the SD card.
≥ To physically format, connect this unit to the
AC adaptor, select [OTHER FUNCTION] #
[FORMAT MEDIA] # [SD CARD 1] or [SD
CARD 2] from the menu, and touch [YES].
Press and hold recording start/stop button in
the following screen for three seconds.
Screen to delete the SD card data is
displayed, so select [YES] and follow the
instruction on the screen.
≥ The customer is responsible for the
management of the data in the SD card.
- 6 -