4.
Remove the power connector cable from the computer (5).
To install the power connector cable, reverse this procedure.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
4.
Remove the power connector cable (see
Remove the display assembly:
1.
Disconnect the display cable (1), and then remove the cable from the clips around the fan (2).
2.
Disconnect the antenna cables from the WLAN module (3).
Preparation for disassembly on page
Bottom cover on page
37).
Power connector cable on page
Battery on page
46).
58).
Display assembly
37).
59