Electrolux EVE8P21X User Manual page 34

1. Clean the inner side of the door with hot
water, so that the residues do not burn
from the hot air.
2. Turn on the oven and select from the
main menu the function: Cleaning. Press
to confirm.
3. Set the duration of the cleaning
procedure:
Option
Quick
Normal
Intense
4. Press to confirm.
When the pyrolytic cleaning
starts, the oven door is locked
and the lamp does not work.
To stop the pyrolytic cleaning
before it is completed, turn off
the oven.
WARNING!
After the function is completed,
the oven is very hot. Let it cool
down. There is a risk of burns.
After the function is completed,
the door stays locked for the
cool down phase. Some of the
oven functions are not available
during the cool down phase.
12.4 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on the
two door hinges.
34 ENGLISH
Description
1 h for a low de‐
gree of dirt
1 h 30 min for a
usual degree of
dirt
2 h 30 min for a
high degree of dirt
A
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each
side and pull it away from the oven at an
upwards angle.
5. Put the door with the outer side down on
a soft cloth on a stable surface.
6. Hold the door trim (B) on the top edge of
the door at the two sides and push
inwards to release the clip seal.
2
B
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence. Install
the smaller panel first, then the larger and the
door.
WARNING!
Make sure that the glasses are
inserted in the correct position
otherwise the surface of the door
may overheat.
A
1